Cayenne S (9PA) V8-4.5L (2003)
/v8-4.5l/Page-432004.png)
Removal
^
The wheel bearing is removed with the wheel bearing housing installed.
1. Remove the corresponding hub cap with puller hook 9229/1 and release the axle nut (fastening nut) before lifting the vehicle. Operate the brake
whilst doing so (2 workers required).
2. Raise vehicle and remove respective front wheel.
3. Remove the axle nut (fastening nut). Perform work up to step 7 in Chapter Removing and installing front drive shaft. Only loosen the brake
caliper.
4. Press out the wheel carrier on the top axle strut (top ball joint) with Press-out tool T 10187.
5. Remove the two holders (brake hose, combination wire) on wheel bearing housing.
6. Hang -brake calliper- using a suitable place in the wheel well.
7. Remove drive shaft. To do this, the first worker must pull out top wheel carrier outwards carefully. 2. Worker must pull out drive shaft carefully.
8. Insert the wheel bearing housing again on the top axle strut (top ball joint) and screw on nut.
