Cayenne S (9PA) V8-4.5L (2003)
Tools
Removal
Note!
^
Remove the two wire retainers on the wheel bearing housing (M6 screw). Disconnect speed sensor plug.
^
Push protection over input shaft..
^
After removing the wheel bearing housing, place the input shaft in such a way that the inner ball joint is not overstretched.
^
Drive shafts must not be left hanging from the joint stop.
1. Remove axle nuts (wheel-side drive shaft fastening). Actuate the brake while doing this.
2. Raise the vehicle and take off the wheel.
3. Remove the brake caliper and the two brake line-A holders and pull plug off the speed sensor. Secure the brake caliper at a suitable position in the
wheel well (do not open the brake system!).