Cayenne S (9PA) V8-4.5L (2003)
15. Tighten torque support fastening screw on the body (M10 x 20) to 60 Nm (44 ftlb.).
16. Install engine compartment cover on the right side. To do this tighten the 4 bayonet screws and the sheet metal screw on the windshield washer
reservoir.
17. Slide design cover under the secondary air pump as shown in the picture.
18. Then press down the 2 rubber mounts on the support. The rubber mounts must engage firmly.
19. Tighten the 4 fastening screws on the ignition coil to 5 Nm (3.5 ftlb.).
Tightening torques