Cayenne S (9PA) V8-4.5L (2003)
13. Tighten torque support fastening screw on the body (M10 x 20) to 60 Nm (44 ftlb.).
14. Install engine compartment cover on the right side. To do this tighten the 4 bayonet screws and the sheetmetal screw on the windshield washer
reservoir.
15. Slide design cover under the secondary air pump as shown in the picture.
16. Then press down the 2 rubber mounts on the support. The rubber mounts must engage firmly.
17. Tighten the 4 fastening screws on the ignition coil to 5 Nm (3.5 ftlb.).
Tightening torques