Cayenne S (9PA) V8-4.5L (2003)
Program the DME control module with new software version.
1.
Connect charger to the power feed for the electrical system battery in the engine compartment and switch on.
2.
Connect the PIWIS Tester with installed test software version 3.0/07/2004 (or higher) to the diagnostic connector and switch it on.
3.
Switch on ignition.
4.
Program DME control module according to the Workshop Manual, Group 2, Chapter 24 70 19.
5.
Switch off the ignition.
6.
Switch off and disconnect the PIWIS Tester.
7.
Switch off the charger and disconnect.
8.
Enter the Workshop Service Action into the Warranty and Maintenance booklet.
Warranty Info:
Damage Code
Time Units
W516 066 000 1
40TU
Labor Operation:
Will automatically be inserted when the damage code is entered.
Reference:
POSES, Diagnostic, Cayenne:
>
Diagnostic: DME 7.1.1 On-Board Diagnosis (OBD II)
Disclaimer