Cayenne S (9PA) V8-4.5L (2003)
19. Press out rubber sleeve "arrow A" and remove lead to pneumatic spring housing.
20. Pull wiring harness inside "arrow B". As space is limited, push the plugs individually past the rear lid hinge.
Installing Wiring Harness For Rear Panel Flap, Left
1. Thread wiring harness out through pneumatic spring housing "arrow". Push the plugs individually past the rear lid hinge.
2. Lay the ground lead in the narrow plug profile "arrow A" and fasten with fabric tape.
3. Push a tie-wire through the pneumatic spring housing "arrows B" and attach ground lead and plug to the wire.
4. Draw tie-wire with wiring harness out through the opening "arrow B" until rubber sleeve "b" engages fully in the opening in pneumatic spring
housing "c".
NOTE: The lead must run over the pneumatic spring.