porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

Removing and Installing Wiring Harness In Engine Compartment|Page 5949 > < Removing and Installing Wiring Harness In Engine Compartment|Page 5947
Page 58
background image

a. Actuate the connectors of the two knock sensors "a" and disconnect.

16. Disconnect the plug connector to the oil level sensor.

a. Actuate the connectors of the two knock sensors "a" and disconnect.

17. Disconnect the plug connectors on the oil pressure switch.

a. Actuate the connector of the oil pressure switch "a" and disconnect.

18. Disconnect the electrical lines on the alternator.

a. Unscrew the fastening nut on the B+ wire. Check for damage to the nut.
b. Press the connector "a" on the rear side of the alternator together and unplug.
c. Remove the electrical lines from the fastening clips.

19. Release cable duct.

Removing and Installing Wiring Harness In Engine Compartment|Page 5949 > < Removing and Installing Wiring Harness In Engine Compartment|Page 5947