Cayenne S (9PA) V8-4.5L (2003)
/v8-4.5l/Page-934003.png)
2.6
Release the connector bracket on the rear seat suspension and pull off socket of the ground strap (arrow A).
3.
Replace previous plug connection by butt joint.
3.1
Position both lines of the control unit-sided wire harness flush on the connector and cut through them individually (Figure 4).
3.2
Position 2 lines coming from side airbag flush on the socket and cut through them individually.
3.3
Unwrap chafing prevention tape to a length of approx. 70 mm on the side airbag wire harness (clearance to slide on the shrink tubing).
3.4
Slide on a shrink tubing onto the blue line of side airbag wire harness.
3.4.1
Strip the blue lines of the side airbag and the wire harness on the control unit side to a length of approx. 8 mm.
3.4.2
Crimp both blue lines with a cable connection.
3.5
Work through black line of the side airbag or control unit wire harness in the same way (= fit shrink-tubing, strip lines 8 mm, crimp with cable
connection).
3.6
Position each shrink tubing over the cable connection and shrink-fit with a hot-air gun (Figure 5).
4.
Complete the modified wire harness.
4.1
Wrap the unwound chafing prevention tape on the modified wire harness around and over the cable connection position. Complete the modified
wire harness with cloth adhesive tape or commercially available electrical tape.
