Cayenne S (9PA) V8-4.5L (2003)
1. Install output shaft speed inductive pickup. To do this, screw in fastening screw.
Tightening torque: 10 Nm (7.5 ft. lbs.)
Note: Screws which are tightened with a torque angle must be replaced with new ones.
2. Install electrohydraulic control unit and screw in new fastening screws.
Tightening torque: 8 Nm (6 ft. lbs.) + 90° torque angle
3. Connect cable plug -2 in overview- for output shaft speed inductive pickup.
4. Install wire set for sensors through opening in the housing.
5. Install ATF temperature sensor -7 in overview- and screw in fastening screw.
Tightening torque: 10 Nm (7.5 ft. lbs.)