Cayenne S (9PA) V8-4.5L (2003)
Note: Noises in drive line
^
Installation position of rubber mounting bulge is incorrect
^
Installation position of mount in housing is incorrect Pay attention to installation dimension of mount to housing
1. Mark centre of bulge in rubber mounting ->Marking for centre of rubber mounting.
2. Position rubber mounting in housing using special tool assembly fixture 9716 a/b/c.
Installation position of rubber mounting
3. Pull in rubber mounting in direction of travel until installation position is reached. Measure distance between assembly fixture ring and housing
using workshop caliper gauge 139. Distance 7.5 mm +/-0.1 mm
Installing rubber mounting for four-wheel final drive, right output side
Rubber mounting for right output side -2-