Cayenne S (9PA) V8-4.8L (2010)
Brake Pad: Technical Service Bulletins
Brakes - PCCB Brakes, Spare Parts Requirements
Service
4
56/10 ENU 4651
Sep 8, 2010
The present document was valid at the time of print. A later version may be available online
Front Axle: Spare Parts Requirements for PCCB Brake Disc
(56/10)
Model year:
as of 2009 up to 2010
Vehicle Type:
Cayenne S (9PA)/Cayenne Turbo (9PA)
Equipment:
PCCB brake disc (I-no. 1LX)
Concerns:
Front axle:
Spare parts requirements for PCCB brake disc (referred to below as "PCCB disc".
Information:
Parts standardization of brake discs for vehicle type Cayenne/92A:
- determine installed version on each axle in case of spare part requirement.
Presently, PCCB discs
955.351.031.00 (front axle, left) and
955.351.032.00 (front axle, right) (referred to below as "955")
are being used up by the parts department, for reasons of parts standardization.
After using up the above-mentioned parts, PCCB discs
958.351.031.50 (left) and
958.351.032.50 (right) (referred to below as ("958")
must be used instead.
Action Required:
In case of spare part requirement, proceed as follows to determine the installed version:
1
Determine which brake disc version is installed on the vehicle. This can be performed by removing a wheel --> 1.1 or (alternatively) via the PIWIS
Information System --> 1.2.
1.1
After removing the wheel, see --> 44051900 Removing and installing wheel, read off the part number stamped onto the brake disc hub.
The stamped part number starts with
7L5: = corresponds to 955 = previous version: --> 3.3
7P5: = corresponds to 958 = new version: --> 4.4
1.2
Alternatively to 1.1: with the following method, it must be noted that, ultimately, the PCCB discs installed on the vehicle are decisive for ordering