Cayenne Titanium (9PA) V8-4.5L (2006)
/v8-4.5l/Page-454010.png)
Inserting ignition rod modules
5. Using the assembly sleeve 9701, press the sealing lip of the hydraulic valve over the hydraulic valve and align it.
Sealing lip with assembly sleeve
Information:
It is best to use a tool that has an addendum of less than 50 mm -A- (see special tool) to tighten the rear fastening screw on the cylinder head cover
close to the plenum panel.
Tool height
6. Position all fastening screws and tighten them in accordance with the correct tightening sequence - Tightening torque: 13 Nm (9.5 ftlb.) -see
figures for both cylinder rows-. Screws -18 and 19 in cylinder row 1 to 4- are inserted later with the torque support bracket.
