Cayenne Titanium (9PA) V8-4.5L (2006)
/v8-4.5l/Page-1314003.png)
Push plug on at the top of the level control module.
3. Code level control module.
4. Calibrate the level control module.
5. Insert the control module into the holder and position with the clip.
6. Store the emergency kit and warning triangle and place on the cover of the right rear side section trim.
Coding level control module
Information:
^
During coding, it is essential to guarantee the power supply for the PIWIS Tester 9718. It is essential to connect a battery charger with a current
rating of at least 40 A to the vehicle battery.
^
The PIWIS Tester 9718 instructions take precedence and in the event of a discrepancy these are the instructions that must be followed. Deviations
may occur with later software versions.
^
The procedure described here has been structured in general terms; different text or additions may appear in the PIWIS tester 9718.
1. Connect the PIWIS tester 9718 to the vehicle and start it. Switch on the ignition. >> continue.
2. Select vehicle type using the cursor keys.
3. Using the >> key, move from the vehicle type to the list of control modules.
4. Select Level control and press the >>
5. Select Coding and press the >>
6. Select Select country and code with the F8
7. Read out fault memory and erase if required.
Calibrating the level control module
Information:
^
During coding, it is essential to guarantee the power supply for the PIWIS Tester. It is essential to connect a battery charger with a current rating
of at least 40 A to the vehicle battery.
^
The PIWIS Tester 9718 instructions take precedence and in the event of a discrepancy these are the instructions that must be followed. Deviations
may occur with later software versions.
^
The procedure described here has been structured in general terms; different text or additions may appear in the PIWIS tester 9718.
Information, measuring points, procedure, and conditions for calibration:
1. Connect the PIWIS tester 9718 to the vehicle and start it. Switch on the ignition. >> Continue.
