Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
Garage Door Opener Control Head: Service and Repair
Removing And Installing Control Unit For Garage Door Opener
Removing control unit for garage door opener
1. Remove ignition key.
2. Remove cover for interior light. From side of windscreen, grasp centre of bulb cover and pull down. Unclip light unit cover and undo both
fastening screws.
3. Open the glasses compartment and undo both fastening screws.
4. Detach roof console around sliding roof switch on roof liner and allow it to hang down to the front.
5. Compress lock -arrows a- on electric plug for garage door opener control unit and pull off plug.
6. Unscrew both fastening screws.
Installing control unit for garage door opener
1. Push electric plug onto control unit until it is felt to engage.
2. Position control unit on the PCB and secure with the two fastening screws.
INFORMATION: Observe the line routing, danger of pinching.