porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

Trunk / Liftgate|Part 1|Page 5992 > < Trunk / Liftgate|Part 1|Page 5990
Page 10
background image

INFORMATION:  When connecting plugs, observe colour marking -a- on antenna amplifier.

18. Push connector onto white connection -b- of right antenna amplifier -arrow D-.

19. Push connector through under the support -arrow A-.
20. Push the connector onto the GPS sensor -arrow B- until the locking tab -C- is felt to engage.
21. Screw down the GPS sensor with both fastening screws -arrows 3-.

Installing Wiring Harness For Rear Window, Right

1. Tie water line and the individual lines together with fabric tape -A-.
2. Secure lines with fabric tape to the flat side -arrow B- of the combination plug.
3. Push wire harness along hinge through pneumatic spring housing -arrows C-.
4. Pull out wire harness in a downward direction -arrow D-. If necessary, push lead from the outside.

INFORMATION:  When installing the wire harness, make sure the insulation of the line is not damaged.

5. Remove fabric tape and lay leads to the connection points.

6. Join up water line -arrows A- until it is felt to engage.

Trunk / Liftgate|Part 1|Page 5992 > < Trunk / Liftgate|Part 1|Page 5990