Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
8. Unclip the brake line to left front wheel out of the bracket underneath the relay carrier.
9. Remove the brake master cylinder.
10. Loosen two M6 screws on the lower closing panel -arrows- (upper screw head covered) (shown here when fitting the brake booster, relay carrier
removed).
Information
If the rubber bushes stick to the holders in the plenum panel when removing the relay carrier, these must be fitted in the openings provided before
being inserted again.
11. Release the relay carrier in the plenum panel and hinge it to one side. To do this, unclip the six plugs in the rear section of the relay carrier
(-arrow- and right marking).
12. Remove the cover under the dashboard on the driver's side in the passenger compartment.
13. Pull off connector of stop light switch -arrow- and remove the complete holder.