Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
10. Join the closing panel using the two M6 screws -arrows- (shown here when fitting the brake booster - relay carrier removed).
11. Join the brake line in the front left wheel housing (remove sealing plugs).
12. Install front left wheel housing liner.
13. Clip the brake line to left front wheel in the bracket underneath the relay carrier in the plenum panel.
14. Connect the plug on the distance sensor of the brake booster.
15. Connect vacuum pipe to the brake booster.
16. Fit brake master cylinder.
17. Fit left plenum panel partition.
Subsequent work
1. Fit the right and the rear covers and the cowl panel.
2. Install both wiper arms.
3. Bleed the vehicle.
4. Calibrate the pressure sensor with the Porsche System Test