Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
/v8-4.8l_turbo/Page-250008.png)
Retaining device
10. Place piston pin and connecting rod in installation position. Ensure that the connecting rod marking is facing the exhaust side and the combustion
chamber recess is facing the center of the engine during assembly. Direction of travel arrow on the piston must be in direction of travel.
11. Slide the oiled piston pin through the piston pin eye and through the connecting rod eye. Tap in carefully with a rubber hammer if necessary.
12. Fit the second piston-pin circlip using the same procedure. Align the ring gap so that it is facing downwards, away from the piston crown (6
o'clock position, 11'o'clock position optional).
13. Check connecting rod and piston for smooth operation.
14. Fit connecting-rod bearing shells in connecting-rod big end and connecting-rod bearing cover. The retaining lugs must be positioned in the
appropriate grooves and on the same side -B and C-. The matching numbers -A- must be the same and must be on the same side (pointing to the
exhaust side when installed). Tighten the connecting-rod bolts by hand and position the complete connecting rod ready for assembly.
Position of bearing shells
Surface with connecting rod number marking (exhaust side)
Subsequent work
1. Install piston.
