Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
Bar ignition modules and valve cover, cylinder bank 5 to 8
1
- Valve cover for cylinder bank 5 to 8 (align over bar ignition modules)
2
- Eyelet
3
- M8 screw
4
- M6 screw
5
- Bar ignition module
6
- Screw for bar ignition module
7
- sheet metal holder
8
- Cap
A - Direction of travel
- Not shown; design cover on bar ignition modules
Removing cylinder head cover (valve cover)
Notice
Valve cover fitted and screwed on incorrectly
Incorrect installation position of hall sender with respect to the camshaft
Risk of engine damage
Fault entries in the DME control unit
-
Align the valve cover carefully over the fitted ignition rod modules.
1. Pull off the cap and the cable plug for the hydraulic valve lying beneath it by pressing on the wire clip -a-.
Cap and cable plug of the hydraulic valve
2. Loosen the two ground points on the valve covers. -1-