Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
3
- Screw, M8 Tightening torque: 23 Nm (17 ftlb.)
4
- Screw, M6 Tightening torque: 13 Nm (9.5 ftlb.)
5
- Bar ignition module
6
- Bar ignition module screw - Tightening torque: 10 Nm (7.5 ftlb.)
7
- sheet metal holder
8
- Cap
A - Direction of travel
- Not shown; design cover on bar ignition modules - Tightening torque: 4.4 Nm (3.0 ftlb.)
6. Fit wire harness holder. To do this, press on the wire harness holder.
Wire harness holder
7. Connect the cable plug for the hydraulic valve and fit the cap.
Cable plug
8. Fit the two ground points on the valve covers. -1-
Engine wire harness, timing case and valve cover
1
- Screw, M6 x 12 - Tightening torque: 10 Nm (7.5 ftlb.)