Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
Bar ignition modules and valve cover, cylinder bank 5 to 8
1
- Valve cover for cylinder bank 5 to 8 (align over bar ignition modules)
2
- Eyelet
3
- Eyelet (with steel screw) - Tightening torque: 23 Nm (17 ftlb.)
4
- Aluminium screw, M6 x 30; always use new aluminium screws; - Initial tightening: 4 Nm (3 ftlb.) and - Final tightening: 90 degrees
5
- Bar ignition module
6
- Aluminium screw, M6 x 20; bar ignition module; always use new aluminium screws; - Initial tightening: 4 Nm (3 ftlb.) and - Final tightening:
90 degrees
7
- sheet metal holder
8
- Cap
A - Direction of travel
- Not shown; design cover on bar ignition modules - Tightening torque: 4.4 Nm (3.0 ftlb.)
6. Fit wire harness holder. To do this, press on the wire harness holder.
Wire harness holder
7. Connect the cable plug for the hydraulic valve and fit the cap.
Cable plug