Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
5. Remove intake manifold.
6. If there is dirt or dust under the intake manifold, clean the affected components.
Installing intake manifold
INFORMATION: If you find leaks at the connection point between the intake manifold and turbocharger (drops of engine oil), the intake manifold
and screw-type clamp must be replaced.
1. If there is dirt or dust under the intake manifold, clean the affected components.
2. Fit the intake manifold on the turbocharger using a new screw-type clamp.
3. Complete the connections on the intake manifold and tighten the screw-type clamp to the specified tightening torque. -2- - Tightening torque: 7
Nm (5 ftlb.)
Subsequent work
1. Complete the intake system.
2. Fit the mass air flow sensor (MAF sensor).
3. Fit the air-cleaner element.
4. Clean any oil stains off the underbody panelling.