Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
Coolant pump
1
- Coolant pump
2
- Seal; rubber seal fitted in coolant pump
3
- Screw, M6 x 25 - For tightening sequence, see below - Tightening torque: 10 Nm (7.5 ftlb.)
A - Direction of travel
Tightening sequence for coolant pump
Removing coolant pump
Information
To ease removal, spray the pulley from the rear side with an anti-corrosion agent.
1. Loosen the three fastening screws on the coolant pump pulley. -arrows- Block the pulley with a holder Nr.38 or brace Nr.193 if necessary or if the
belt drive is removed.
Fastening screws for coolant pump pulley
2. Loosen drive belt around the water pump.