Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
Air Door Actuator / Motor: Service and Repair
Removing and Installing Servo Motor
Removing And Installing Servo Motor
Technical values
Preliminary work
1. Remove trim under dashboard on left.
2. Remove KESSY/immobiliser control unit.
3. Remove vehicle electrical system control unit.
4. Remove relay carrier. Remove relay carrier holder.
Removing servo motor
INFORMATION:
-
The air conditioning servo motor -B- - outer unit aimed at persons on left - is located on the left air conditioning unit.
-
The air conditioning servo motor -C- - centre unit aimed at persons on left - is located on the left air conditioning unit.
-
The individual servo motors -B and C- are not installed on both sides of the air conditioning unit in vehicles with a manual air conditioner. These
are replaced by just one air conditioner servo motor, which is installed on the left side of the air conditioning unit at the servo motor position -B-.
-
Switch ignition off and remove ignition key before starting work.
1. Unscrew the fastening screws -Arrows 1- on the retainer plate with the motors -D and E-.
2. Press the electric connectors -Arrows 2- ( -Arrows a- ) and pull off the connectors.
3. Pull retainer plate with the motors -D and E- downwards out of the guide.