Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
/v8-4.8l_turbo/Page-826004.png)
11. Unscrew fastening screws -A- and remove servo motor -B- for distributor flap for side vents at passenger's side.
Installing servo motor for four-zone air conditioning
1. Place the servo motor on the upper retainer plate and screw down using the fastening screws. - Tightening torque: 1.5 Nm (1.0 ftlb.)
2. Connect electric plug connections to the servo motors until the connectors engage securely.
INFORMATION:
-
Switch on ignition and carry out the service position menu, Drive links menu with the Porsche System Tester in the Climatronic.
-
As an alternative, the servo motors can also be powered with 12 volts until they have reached the correct position. Always use the circuit diagram
for this.
3. Set the upper servo motors to service position using the PIWIS Tester P 9718. The drive mechanisms must be positioned as shown.
INFORMATION: Make sure that the drivers of the servo motors are pushed into the mountings.
4. Insert upper retainer plate with the servo motors from below as far as it will go into the guides on the air-conditioning unit.
