porsche Workshop Repair Guides

Porsche Workshop Service and Repair Manuals

Diagram Information and Instructions|Page 4930 > < Diagram Information and Instructions|Page 4928
Page 1
background image

Compressor HVAC: Service and Repair

Removing And Installing Air Conditioning Compressor

Technical values

Preliminary work

1. Draw off and dispose of refrigerant in the air-conditioning system in accordance with regulations.
2. Remove front left wheel.

INFORMATION:  Only for vehicles with Porsche Dynamic Chassis Control (PDCC).

3. Remove left wheel housing liner.

INFORMATION:  Only for vehicles with Porsche Dynamic Chassis Control (PDCC).

4. Remove left air cleaner housing.
5. Remove engine guard.
6. Remove drive belt.

Installing air conditioning compressor

Work steps for blocked/seized up air conditioning compressor

1. Remove desiccator from the condenser.
2. Check the desiccator for wear/chips.

If there is wear/chips:

3. Remove the refrigerant line between the compressor and condenser.
4. Replace the refrigerant line between the compressor and condenser.
5. Replace the condenser with desiccator.
6. Install the new refrigerant line between the compressor and condenser.

If there is no wear/chips:
-

Replace the desiccator.

Subsequent work

1. Install drive belt.
2. Install engine guard.

INFORMATION:  Only for vehicles with Porsche Dynamic Chassis Control (PDCC).

3. Install left air cleaner housing.

INFORMATION:  Only for vehicles with Porsche Dynamic Chassis Control (PDCC).

4. Install left wheel housing liner.
5. Fit front left wheel.
6. Fill refrigerant on the air conditioner in accordance with regulations.
7. Open air outlet nozzles on the dashboard, and set fan to at least 75 %.
8. After allowing the system to stabilise at idle speed (approx. 5 sec.), switch on air conditioning and allow the engine to run uninterrupted for at least

2 minutes at an engine speed of less than - Engine speed: 1500 rpm.

9. Switch off the air conditioning again. Do not drive until the air conditioner has been filled.

INFORMATION:  Only for vehicles with Porsche Dynamic Chassis Control (PDCC).

10. Park the vehicle in an open area and bleed Porsche Dynamic Chassis Control (PDCC).

Removing And Installing Air Conditioning Compressor

Tools

Diagram Information and Instructions|Page 4930 > < Diagram Information and Instructions|Page 4928