Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
3. Press in latch of electrical plugs and pull the plugs up and off.
Installing front air-conditioning system regulator
1. Insert electrical plugs in the air-conditioning control until they are felt to engage.
2. Carefully slide the control into the installation slot, paying attention to the electrical leads. The left and right latches must engage.
3. Fit the covering frame and press into place until it is felt to engage.
Coding air-conditioning regulator
INFORMATION:
-
If the control unit for the air-conditioning control is replaced, it must be programmed using the Porsche System Tester. This is to adapt the control
unit to the vehicle and equipment.
-
If possible, before the control unit is removed and replaced, a read-out of the codes should be obtained from the Porsche System Tester.
-
During coding, it is essential to guarantee the power supply for the Porsche System Tester. It is essential to connect a battery charger with a current
rating of at least 40 A to the vehicle battery.
-
Symbol for the Tab key = ?|
-
The Porsche System Tester instructions take precedence and in the event of a discrepancy these are the instructions that must be followed.
Deviations may occur with later software versions.