Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
1. Remove the plugs on the suction line, check the O-rings and replace if in doubt.
2. Raise the auxiliary air-conditioning unit and push the suction line onto the connections -arrows- and screw down with both fastening screws -1-. -
Tightening torque: 12 Nm (9.0 ftlb.)
3. Ensure that the water drain is connected to the drain when fitting the auxiliary air-conditioning unit.
Subsequent work
1. Fill in refrigerant.
2. Screw down auxiliary air-conditioning unit
3. Install rear side trim panel.
Removing and Installing Vehicle Floor Intake Pipe (Low Pressure)
Removing And Installing Vehicle Floor Intake Pipe (Low Pressure)
Technical values
Preliminary work
Preliminary work - removing front vehicle floor suction line
1. Remove left front wheel.
2. Remove left front wheel housing liner.
3. Remove left centre cover.