Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
Tail Lamp: Service and Repair
Removing And Installing Rear Light
Removing rear light
CAUTION:
Risk of short circuit.
-
Before removing tail lights, remove ignition key and switch off light.
1. Open rear lid.
2. Remove rear light.
2.1. Unclip both caps -1- using a small screwdriver -arrow-.
2.2. Undo the two fastening screws -2-.
3. Remove the rear light.
3.1. Remove rear light -1- to the back in -direction of arrow- using the ball head -2- from the clip nut -3-.
3.2. Release connector -4- ( -arrow A- ) and pull it off the rear light -1- ( -arrow B- ).
3.3. Remove rear light -1-.
Installing tail light
1. Install tail light.
1.1. Push connector -4- onto the tail light -1- ( -arrow A- ) until it engages securely -4-.
INFORMATION: Check condition of clip nut and replace it if necessary.
1.2. Press tail light -1- with the ball head -2- into the clip nut -3- and position it on the body.