Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
Preliminary work - removing rear vehicle floor suction line
1. Remove left rear wheel.
2. Remove left rear wheel housing liner.
3. Remove left centre cover.
Removing the vehicle floor intake pipe
Removing front vehicle floor suction line
CAUTION:
Danger of injury from contact with the refrigerant
-
Observe safety regulations when working with refrigerant.
INFORMATION: Remove and install the pressure line together with the suction line.
1. Remove refrigerant by suction.
2. Unscrew the fastening screws -2- for the refrigerant lines, then seal the refrigerant lines -A- (low pressure) and -B- (high pressure) and the
connections with plugs.
3. Unscrew the fastening screws -4- for the refrigerant lines -A- and -B-.
4. Unscrew the fastening screws -5- of the support for the refrigerant lines -A- , -B- and coolant lines -C-.
5. Unclip lines -A, B, C- from the support.
6. Unscrew the fastening screws -4- for the refrigerant lines -A- , -B- and for the coolant line -C-.
7. Unscrew the fastening screws -2- for the refrigerant lines, then seal the refrigerant lines, -A- (low pressure) and -B- (high pressure), and the
connections with plugs.
8. Pull out refrigerant lines -A- (low pressure) and -B- (high pressure) together. Unclip lines from the retaining clips.
Removing the rear vehicle floor suction line