Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
10. Unclip the cover from the power distributor using a screwdriver -arrow a-.
11. Carefully prise out the locking mechanism on the electric connector -1- with a screwdriver -arrow a- and pull the connector out of the cutoff relay
-2-.
12. Screw off the two fastening nuts -3- on the cutoff relay -2- and remove the cutoff relay.
Installing Cutoff Relay
Installing Pyrotechnical Cutoff Relay
INFORMATION: Use new nuts.
1. Position the cutoff relay -2- in the power distributor. Screw on the two fastening nuts -3- on the cutoff relay. - Tightening torque: 20 Nm (15 ftlb.)
2. Connect electric connector -1- to cutoff relay and lock it -arrow a-.
3. Slide cover of power distributor from front to back -arrow A- and press it on -arrow B- until the latch locks into place.
INFORMATION: Only for vehicles with auxiliary battery.