Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
Removing And Installing Main Wiring Harness - Floor Area And Left-Hand Side
Removing Main Wiring Harness - Floor Area And Left-hand Side
Overview
INFORMATION:
-
The repair instructions document "Main wire harness" is divided into several chapters because of its size.
-
For body repairs, refer to the specific chapters on installing and removing individual sections of wiring.
CAUTION:
-
The main wire harness contains all airbag lines, antenna lines and optical waveguides.
-
The main wire harness must therefore not be cut for major repair work and must be replaced complete.
-
If individual lines are damaged, isolate them (disconnect, remove plug contacts from plug connections etc.) and replace the original wire
harness by installing new lines.
Removing Main Wiring Harness - Floor Area And Left-hand Side
Disconnect the battery
Remove side trim panel for rear luggage compartment.
Remove left rear light.
Remove rear seat
Remove left B-pillar trim panel
Remove front left side-section trim panel
Remove subwoofer
Remove auxiliary battery
Remove Floor Carpeting From The Work Area
CAUTION:
Danger of injury and material damage if airbag units are not handled correctly. Always observe the safety regulations for handling airbag
units.
-
Remove ignition key. Disconnect battery. Route or isolate the ground strap so that all contact with a ground carrier (e.g. body, seat
frame) is avoided.
-
After the battery is disconnected, always wait for 1 minute before disconnecting the airbag plugs.
1. Lift vehicle.
Only for vehicles with off-road stabiliser and/or tyre pressure monitoring system