Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
13. Press down protective cover (B-pillar) on connector -Arrow A- and maintain in this position.
14. Insert the connector -Arrow B- until the locking tab -C- is felt to engage.
15. Fit ground straps together with twist lock on the threaded bolt -Arrow D- and secure with fastening nut -1-. - Tightening torque: 6.5 ftlb.
16. Fit wiring duct (lower C-pillar) on threaded bolt and wheel housing seam -arrows-.
17. Install airbag sensor on rear wheel housing.
18. Push line through the opening -arrow- (lower C-pillar) and, together with the rubber sleeve, fasten in the floorpan.
19. Place line in the installation position (lower C-pillar) and close the tie-wrap -Arrow A-.
20. Push line and retaining clip onto threaded bolt -Arrow B-.
21. Fit ground straps together with twist lock on the threaded bolt and secure with fastening nut -1-. - Tightening torque: 6.5 ftlb.
Only For Vehicles With Auxiliary Battery
22. Fit B+ line at the holders (along left wheel housing) on the threaded bolts -arrows-.