Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
/v8-4.8l_turbo/Page-437006.png)
5.1. Unscrew two M6 screws -2- and one M8 collar nut -3- and remove the heat shield.
6. Lower the fuel tank.
6.1. Place a transmission jack (e.g. transmission jack V.A.G 1383 A WE 1082 ) in position to support and secure the fuel tank.
6.2. Unscrew fastening screws for the restraining straps and carefully lower the fuel tank.
7. Open all line brackets on the underbody and remove the wire harness.
Installation
Installing fuel line
INFORMATION:
-
The description applies to all engine types.
-
The setup and procedures required may differ slightly from the illustrations or procedures described due to engine-specific differences.
1. Position the vehicle-specific wire harness on the tank and in the engine compartment
1.1. Secure the wire harness with the line brackets