Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
2.2.2 Fit center bearing holder for new cardan shaft at the body and align it with the pins (--> Figure 6 -arrows-). Loosely pre-fit holder using
six new hexagon-head bolts (M10 x 30, --> Figure 6 -1-) --> Workshop Manual '393519 Removing and installing rear cardan shaft -
section on "Installing"'.
2.2.3 Secure rear cardan shaft to the rear axle differential flange using six new cheese head bolts (M10 x 45) and three plates --> Workshop
Manual '393519 Removing and installing rear cardan shaft - section on "Installing"'.
Tightening torque 30 Nm (22 ftlb.) +90 degrees
2.2.4 Secure rear cardan shaft to the transfer gear flange using three new hexagon-head bolt (M12 x 1.5 x 65, --> Figure 7 -1-), three A13
washers (--> Figure 7 -2-) and three M12 hexagon nuts (--> Figure 7 -3-) --> Workshop Manual '393519 Removing and installing rear
cardan shaft - section on "Installing"'.
Tightening torque 60 Nm (44 ftlb.)
2.2.5 Tighten the six hexagon-head bolts (M10 x 30, --> Figure 6 -1-) on the center bearing holder --> Workshop Manual '393519 Removing
and installing rear cardan shaft - section on "Installing"'.
Tightening torque 60 Nm (44 ftlb.)
2.2.6 Centre the cardan-shaft center bearing using the centering tool 9680 and tighten the two hexagon-head bolts (M8 x 16, --> Figure 6 -2-)
--> Workshop Manual '393519 Removing and installing rear cardan shaft - section on "Installing"'.
Tightening torque 20 Nm (15 ftlb.)
2.2.7 Install exhaust system --> Workshop Manual '260119 Removing and installing exhaust system on DFI engines - section on "Installing"'.
3. Add letter to engine number.
The engine number is located on the left side close to the oil pan/short engine flange in direction of travel --> Figure 8.
NOTE:
If there is no space for the letter "S" at the end of the engine number, it can even be stamped under the first number after the engine type "M48/51".