Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
5.1.3 Disconnect electric plug connection for brake pad wear indicator (--> Figure 11 -1-) and disengage lines form the bracket (--> Figure
11 -2-).
5.1.4 Remove front brake caliper --> Workshop Manual '47391900 Removing and installing front brake caliper - section on "Removing"'
(--> Figure 11).
5.1.5 Remove front brake disc --> Workshop Manual '46501950 Removing and installing front brake disc - section on "Removing"'.
5.2
Clean the flat and centering surfaces of the brake disc at the wheel carrier and then apply a thin layer of Optimoly TA.
5.3 Remove cover plate (brake anchoring plate) and install new brake anchoring plate on the wheel carrier using three new hexagon-head bolts
(M8 x 12) on each side (--> Figure 12 -1-).
Tightening torque 20 Nm (15 ftlb.)
Part 2
5.4 Remove brake hose/wiring harness holder (--> Figure 12 -2-) at the wheel carrier and fit new holder on the wheel carrier with a screw (M8 x
14).
Tightening torque 30 Nm (22 ftlb.)
5.5 Install new front brake disc according to vehicle side and rolling direction using a new Torx screw (M12 x 1.5 x 19.3) --> Workshop Manual
'46501950 Removing and installing front brake disc - section on "Installing"'.
Tightening torque 14 Nm (10.5 ftlb.)
5.6 Complete the new brake caliper.
5.6.1 Fit new brake pads (2 ea. --> Figure 13 -1-) in the brake caliper --> Workshop Manual '463619 Removing and installing front brake
pads - section on "Installing"'. Retaining pin for brake pads:
Tightening torque 30 Nm (22 ftlb.)