Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
6. Pull out wire harness -1- under the hydraulic unit. Remove armouring and disconnect ground strap from bonnet wire harness.
7. Open the three retaining clips -arrow B- and take out wire harness.
8. Expose wire harness from Porsche Stability Management control unit connector up to foam grommet -1- in the firewall. To do this, remove the
corrugating hoses and the armouring.
9. Release the cap on the Porsche Stability Management control unit connector 4x -arrows a- and take off.
10. Remove tie-wrap -1- on Porsche Stability Management control unit connector.
11. Open secondary locking on the Porsche Stability Management control unit connector.
INFORMATION:
-
If necessary, mark the electric lines.
-
For allocation, see wiring diagram (depending on the model year)