Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
1. Position support for DME control module and screw down both fastening nuts -3- and the fastening screw -2-. - Tightening torque: 6 ftlb. -
Tightening torque: 6 ftlb.
2. Insert DME control module in the retaining clips -arrow A- and close the retaining clips -arrow B-.
3. Mount ground straps together with the twist lock on the stud and screw down with the fastening nut -1-. - Tightening torque: 6.5 ftlb.
Subsequent Work
1. Install DME control module.
2. Install cowl panel cover.
3. Connect the battery and carry out work instructions after disconnecting the battery.
Reworking Main Wire Harness
Reworking Main Wire Harness
Tools
Preliminary Work
1. Disconnect battery.
2. Remove cover under dashboard right.
3. Remove front right side section trim.
4. Remove front right seat frame.
Reworking Main Wire Harness
Rework Main Wire Harness (connection Points A And B) - Side Member Area On The Right