Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
33.4. Clip in wire harness on the intake manifold -arrow C- and push in retaining clips for wire harness on the intake manifold -arrow D-.
34. Install support for DME control unit.
34.1. Position support for DME control unit -arrow- and secure with the fastening nuts -3- and fastening screw -2-. - Tightening torque: 8 Nm (6.0
ftlb.) - Tightening torque: 8 Nm (6.0 ftlb.)
34.2. Insert wire harness for DME control unit into the retaining clips -arrow A- and close the retaining clips -arrow B-.
34.3. Fit ground straps together with the twist lock to the stud and secure with the fastening nut -1-. - Tightening torque: 9 Nm (6.5 ftlb.)
Subsequent work
1. Install relay carrier in plenum chamber E-box.
2. Install wiper motor.
3. Install DME control unit.
4. Install filler neck on tank for windscreen washer system.
5. Install coolant reservoir.
6. Install air cleaner housing.
7. Install front apron.
8. Install main headlight at the left and right.
9. Install front wheel housing liner at the left and right.
10. Install linings in engine compartment.
11. Carry out work instructions after disconnecting the battery.
Removing and Installing Front Wire Harness
Removing And Installing Front Wire Harness
Preliminary Work
1. Remove front apron.
Removing Front Wire Harness