Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
4. Take front wire harness -1- out of the air grille holders at the left and right -arrows-.
5. Unclip front wire harness -1- at the left and right -arrows- and cut tie-wraps -2-.
6. Unclip front wire harness -1- in the middle -arrows- and cut tie-wraps -2-.
7. Pull off connector on sensors for ParkAssist.
7.1. Release clips -arrows A- and remove sensor for ParkAssist -1- ( -arrow B- ).
7.2.
Release connector -2- ( -arrow C- ) and pull it off the sensor for ParkAssist -1- ( -arrow D- ).
8. Remove front wire harness.
Installing Front Wire Harness
1. Plug in connector on sensor for ParkAssist.
1.1. Plug in connector -2- on sensor for ParkAssist -1- ( -arrow A- ) until the connector -2- engages securely.