Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
/v8-4.8l_turbo/Page-667061.png)
INFORMATION:
-
The repair instructions document "Main wire harness" is divided into several chapters because of its size.
-
For body repairs, refer to the specific chapters on installing and removing individual sections of wiring.
Installing Main Wiring Harness - Floor Area And Left-hand Side
Install main wire harness - dashboard area & centre console.
1. Fit wire harness with wiring duct (rear door floor area) on threaded bolts -Arrows A- and fasten with two new tie-wraps -B-.
2. Fasten wire harness in central electrical system power distributor.
3. Connect line (central electrical system power distributor) to threaded bolt -Arrow A- and tighten with the fastening nut. -2-. - Tightening torque:
4.5 ftlb.
Only For Vehicles With Auxiliary Battery
4. Connect line to threaded bolt -Arrow B- and tighten with the fastening nut. -3-. - Tightening torque: 12 ftlb.
5. Close cap -Arrow C- until locking tabs -a- are felt to engage.
6. Push connector onto airbag sensor at B-pillar.
