Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
57. Push connector onto antenna for tyre pressure monitoring system -1- (rear wheel housing) -Arrow A- until locking tab -B- is felt to engage.
58. Connect plug connection for off-road stabiliser -2- -Arrow C- until locking tab -D- is felt to engage.
Connect the battery.
Part 1
Removing And Installing Main Wiring Harness - Floor Area And Right-Hand Side
Removing Main Wiring Harness - Floor Area And Right-hand Side
General Information
INFORMATION:
-
The repair instructions document "Main wire harness" is divided into several chapters because of its size.
-
For body repairs, refer to the specific chapters on installing and removing individual sections of wiring.
CAUTION:
-
The main wire harness contains all airbag lines, antenna lines and optical waveguides.
-
The main wire harness must therefore not be cut for major repair work and must be replaced complete.
-
If individual lines are damaged, isolate them (disconnect, remove plug contacts from plug connections etc.) and replace the original wire
harness by installing new lines.
Removing Main Wiring Harness - Floor Area And Right-hand Side
Disconnect the battery
Remove Kessy antenna on rear impact member
Remove right rear light
Remove TV tuner
Remove control unit for level adjustment
Remove control unit for trailer hitch
Remove CD changer
Remove loudspeaker amplifier
Remove tilt sensor control unit
Remove rear seat
Remove right B-pillar trim panel
Remove front right side-section trim panel
Remove floor carpeting from the work area.
Remove right rear wheel housing liner.