Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
Tires: Service and Repair
Mounting Tires (Removing and Installing Tires) - For Vehicle With and Without TPM
WM 444019 Mounting tires (removing and installing tires) - for vehicles with and without TPM
Tools
Tire removal/mounting machine
Only use recommended tire removal/mounting machine and auxiliary equipment (special mounting lever, bead holding down device).
WE 1084 Tire removal/mounting machine
Auxiliary equipment
Auxiliary equipment
1 -
Special mounting lever with plastic protection.
2 -
Holding-down device 9539 - for holding down the tire bead.
3 -
Wulstboy - for holding down the tire bead (alternative to holding-down device 9539/item 2)
4 -
Adhesive weight remover - commercially available
Requirements/information on removing/mounting tires
Information
-
Tire temperature during removal/mounting must be approx. 20°C (at least 15°C). Allow enough time to heat the vehicle/tires in a suitable
environment if necessary (at room temperature of more than 15°C). Example: If the room temperature of the workshop is approx. 20°C and the tire
temperature is approx. -15°C, approx. 3 hours are required to heat the tires to the required temperature.
-
Before removal/mounting it is important to establish whether a Tire Pressure Monitoring system (TPM) is fitted! The tire valve serves as the
distinguishing feature. Without TPM: rubber valve. With TPM: aluminium valve. If a TPM system is fitted, read the special information on the
Tire Pressure Monitoring system (see module in this main chapter).
-
Vehicles with TPM: Before changing a tire, read out the remaining life span of the wheel electronics unit (battery capacity) using the PIWIS