Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
-B- - Valve complete (No. 2 to No. 7)
-1- - Self-locking (Torx) fastening screw
-2- - Valve cap (plastic)
-3- - Valve insert
-4- - Union nut
-5- - Washer chamfered on both sides
-6- - Bead seat sealing ring
-7- - Valve
The valve -B- must be replaced if:
-
The wheel electronics unit -A- is removed
-
The self-locking fastening screw -1- is loose
-
The union nut -4- is loose
-
The valve -7- is leaking at the valve seat
-
The valve -7- (valve body) is bent or broken.
The wheel electronics unit -A- must be replaced if:
-
The housing is visibly deformed
-
The filter surface (on the bottom) is so soiled that it cannot be cleaned by wiping
-
Tire sealant (tire sealing liquid) has been used
Instructions for fitting the TPM valve are provided below.
1. Loosely fit the wheel electronics unit -A- at the valve -7- (do not tighten screw -1-). Insert this assembly into the valve bore (of the rim) with the
bead seat sealing ring -6-.
Fit washer, chamfered on both sides, -5- and screw on the union nut -4- until it is seated correctly.
TPM valve