Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
housing in front of the converter -inset-.
Installation position of torque converter
Caution
Leaks due to incorrect assembly sequence of torque converter
-
Leaks after a new sealing ring was fitted
-
Leaks following installation of the torque converter
-
Observe installation instructions
5. When sliding in the torque converter -1-, the sealing lip of the shaft sealing ring can bend over because of a ridge on the torque converter -1-.
-bottom arrow-
Sealing lip bent in
Positioning sealing lip
6. Pull torque converter -1- out by approx. 5 mm. This moves the shaft sealing ring back into its correct installation position.
7. Push torque converter as far as it will go onto the transmission shaft.