Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
Installing rubber mounting for four-wheel final drive, drive side
Rubber mounting, drive side -1-
Information
Noises in drive line
-
Installation position of rubber mounting bulge is incorrect Rubber mounting bulge must be installed vertically into housing
-
Installation position of mount in housing is incorrect Pay attention to installation dimension of mount to housing
1. Mark center of bulge in rubber mounting.
Marking for center of rubber mounting
2. Position rubber mounting in housing using special tool assembly fixture 9716 a/b/c.
3. Pull in rubber mounting in direction of travel until installation position is reached. Measure distance between assembly fixture ring and housing
using workshop caliper gauge 139. - Distance: 7.5 mm ±0.1 mm