Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
Preliminary work
1. Release fastening nut for drive shaft.
2. Remove wheel.
Tools
Tools - Removing and installing front drive shaft
-A- - Universal drive shaft/wheel hub puller as of model '86 NR.87-1
-B- - Protective tube - To protect the drive shaft.
-C- - Press-out tool T10187
-D- - Screwdriver 9546
Removing front drive shaft
Caution:
Increased risk of accidents if the wheel carrier is raised improperly!
-
Injuries and material damage are possible.
-
Do not raise the wheel suspension higher than the normal vehicle position (vehicle resting on wheels).
-
When raising the suspension, use a suitable intermediate layer (hard rubber).
-
Do not damage the brake cover plate.
1. Push (press in) peg into the wheel hub with universal drive shaft/wheel hub extractor as of model '86 NR.87-1. - Insertion length: 20 mm+5 mm