Cayenne Turbo (9PA) V8-4.8L Turbo (2008)
9. Unscrew three fastening screws -10- and remove wiper motor.
Installing wiper motor
1. Before attaching wiper motor to wiper linkage, connect wiper motor to electrical plug connection, close bonnet, operate one-touch wipe at least
once and let motor run to the end position. Disconnect plug connection again.
2. Before attaching wiper arms, the wiper motor must be operated a second time at least once with one-touch wipe and run to the end position. Close
bonnet.
INFORMATION: If a new wiper motor is being installed, ensure that the correct Porsche original screws are used.
3. Fit wiper motor to wiper linkage and position it. Screw in fastening screws -10- and tighten to the specified tightening torque. - Tightening torque:
6.5 ftlb.
4. Place linkage on wiper shaft, position it, set dimension -X- = 4 mm between mechanical stop and motor crank (wiper motor) and tighten with
fastening nut -9-. - Tightening torque: 13 ftlb.
5. Position wiper system. Engage support -B- on the body, insert wiper motor with linkage downwards on the driver's side, rotate wiper linkage
slightly and lay it down.
INFORMATION: Observe the order for the fastening screws.