Cayman (987) F6-2.7L (2007)
Commercially available tool for pulling electric wires through.
Installing wire harness for airbag
Installing components for airbag from triggering unit to passenger's airbag unit or seat-belt pretensioner
WARNING:
Danger of injury and material damage if airbag units are not handled correctly.
-
Always observe the safety regulations for handling airbag units
-
Remove ignition key. Disconnect battery. Route or isolate the ground strap so that all contact with a ground carrier (e.g. body, seat
frame) is avoided.
-
After the battery is disconnected, always wait for 1 minute before disconnecting the airbag plugs.
1. Release connector on triggering unit for airbag -10- and fold open the locking lever.
2. Remove connector from the relevant component.
2. 1. Connectors for stage 1 and stage 2 of passenger's airbag unit -1 and 2-.
Release and remove connectors for stage 1 and stage 2 of passenger's airbag unit
2. 2. Connector for seat-belt pretensioner, left -7- and right -8-.
Release and remove connector on seat-belt pretensioner.
Remove rubber sleeves -9-.
2. 3. Cut off the connector of the damaged wire harness, isolate it and secure it to the main wire harness with tie-wraps.
3. Using a small screwdriver, lever the seal out of the connector housing.