Cayman (987) F6-2.9L (2009)
Prerequisites for operating and programming the HomeLink:
-
The ignition is switched on.
-
The fog lights are switched off.
To activate the required equipment:
Press the relevant button -1, 2 or 3-. The LED -A- lights up during signal transmission.
INFORMATION:
Original remote controls for garage door system cannot be taught to operate with the HomeLink in the vehicle. OR: The teaching process was
confirmed, but HomeLink will not work or only works sporadically.
-
Check that the battery in the original remote control for the garage door opener is new. If in doubt, change the battery and repeat the teaching
process.
Operating instructions:
Always use the garage door opener in the direction of travel. Otherwise range limitations cannot be ruled out.
Before selling the vehicle, erase the programmed garage door opener signals on the keypad.
To determine whether the original remote control has a fixed or variable code, please read the instructions for the original remote control.
In the case of a standard fixed code, the LED in the roof console is permanently lit during the transmission process. No further steps are necessary for the
operation of compatible systems.
If the system set is not activated by the garage door opener control unit, this may be because the original remote control has a variable code.
Assigning garage door opener/HomeLink signals to buttons
Garage door opener/HomeLink with fixed code system
INFORMATION:
-
This operation erases the standard codes set in the factory. Do not repeat this operation if additional buttons are to be programmed.
-
Hold the two outer buttons -1 and 3- down for around 20 seconds until the LED -A- starts to flash quickly. All programmed signals for the buttons
-1 to 3- are erased.
1. Press the required button until the LED flashes slowly. You then have around 5 minutes to complete steps 2 and 3.